D
Deleted member 7
Okay so today the owner comes back and ask me to roll up the windows in the door and quarter glass to see if they matched up better than before.. When the old hinges were worn out the driver and passengers side windows had to be rolled down just a tad to get the doors closed properly and then roll the glass back up.. Otherwise they hit..
So here is my question perhaps my situation I may need to correct but dont know how or what to do here..
1. I blasted, straightened and rebuilt the factory hinges.
2. Doors are hung and fit to quarters and I had already fit the fenders to the doors to make sure it all fit..
3. As you can see in the photo below the gap from the inner body to the glass looks insanely off!!!!!
4. The passengers side is off but not as much look at photo..
5. If you look at the drivers side photo ( the 1st one ) the door and rocker meet up flush at the bottom.. see photo below.. Pay no attention to the fender fit.. Its just setting there not secured
6. Lastly the door could be tilted up in the rear and lowered in the front as long as the body lines would still be made to fit, BUT THEN THE DOOR WOULD TOUCH THE ROCKER!!! see photo
So there lies my problem this morning as I sit here scratching my head.. I know there is a rubber that goes in there to fill a pretty good size void, but the drivers side appears to be too far off.. Here is the kicker.. The drivers door sets forward actually a little more than the passengers.. The passengers side door is slightly off at the rocker and does not meet flush, so you would think it would be the furthest out..
Im looking for advice here guys.. Is this the norm or have I got something completely off and just dont realize it
Thanks for any help in advance
So here is my question perhaps my situation I may need to correct but dont know how or what to do here..
1. I blasted, straightened and rebuilt the factory hinges.
2. Doors are hung and fit to quarters and I had already fit the fenders to the doors to make sure it all fit..
3. As you can see in the photo below the gap from the inner body to the glass looks insanely off!!!!!
4. The passengers side is off but not as much look at photo..
5. If you look at the drivers side photo ( the 1st one ) the door and rocker meet up flush at the bottom.. see photo below.. Pay no attention to the fender fit.. Its just setting there not secured
6. Lastly the door could be tilted up in the rear and lowered in the front as long as the body lines would still be made to fit, BUT THEN THE DOOR WOULD TOUCH THE ROCKER!!! see photo
So there lies my problem this morning as I sit here scratching my head.. I know there is a rubber that goes in there to fill a pretty good size void, but the drivers side appears to be too far off.. Here is the kicker.. The drivers door sets forward actually a little more than the passengers.. The passengers side door is slightly off at the rocker and does not meet flush, so you would think it would be the furthest out..
Im looking for advice here guys.. Is this the norm or have I got something completely off and just dont realize it
Thanks for any help in advance