Thanks guys, been making headway too, everything is re-painted except for the bed. Been sitting for a week. hope to sand this weekend and buff the following, then start putting cab together.
How did you form the roll on the edge of the dash "pad" ?
I have done similar bends making dragster bodies. Made a roller out of 2 -1" dia leveller rolls. clamped the metal to the table of the roller, then roll the metal around the lower roll using the upper roll mounted to a set of parallel arms.
At times I wish i still had access to the surplus parts tossed out at the rolling mill
When I get to building my C3 widebody Sebring 75 street replica I plan on a similiar dash setup.. Your use of panels + striping will strongly infulence my finished product!
I think the use of a center pod and using your design on the rest of the dash should kick ass.
We will see when I can drive it around a little more.
Should be about finished next week, other than the buffing and installing seats. I am determned to let it sit a week before sanding and then another week before buffing.