Time to play catch up here..
Vince got two of the milk cans media blasted and worked on the third while I sprayed some SPI epoxy primer on the first two.
Also got some epoxy on the hood brace...
Ends are quite a bit better than before..
I received a state of the art drawing the other day, and was asked if we could duplicate the 1/16 offset shown...
Of course this meant we needed some new tooling..
Our first sample, with the proper 3/4 flange...
We had another panel that would require the offset on two adjacent edges, so one more sample...
video action:
That'll do pig, that'll do.
Some of the upholstery parts have been trickling in... so let's add some bling factor....
….and we made a hand punch for setting the trim tag rivets on the cowl...
video version:
And finally, we also had some 3/8 stainless fuel line to straighten out of it's coil for a big block mopar… Video parts 1, 2, and 3:
.