6
64chevmn
I've sprayed about 2 gallons of unreduced epoxy over the past few months without any problems at all. I'm starting to spray my frame and suspension parts and I'm going for a semi-gloss look. I sprayed the first round of suspension parts with 2 wet coats of unreduced epoxy. I let them sit over night and sprayed them with one more wet coat with 25 percent reduced epoxy. I let the mixed activated epoxy induce for 30 minutes then added the SPI medium reducer; then let it sit for another 15 minutes before spraying.
About 30 minutes after spraying the parts, I noticed a a milky film or something similar to that on portions of the newly primed parts. Most of it goes away after 24 hours, but am I doing something wrong? The garage temp is at 70 degrees with less than 20 percent humidity. It almost seems like the reducer is not mixing well or flashing properly?
Dan
About 30 minutes after spraying the parts, I noticed a a milky film or something similar to that on portions of the newly primed parts. Most of it goes away after 24 hours, but am I doing something wrong? The garage temp is at 70 degrees with less than 20 percent humidity. It almost seems like the reducer is not mixing well or flashing properly?
Dan