P
projectzj
Gentlemen,
Just got done blocking out two coats of 2k regular build (sprayed over epoxy). I plan to do a reduced epoxy sealer coat before going to base. After the blocking I found a few minor areas I need to touch up, i.e. a few pinholes and, one small gouge (very shallow, narrow, and about an inch long), and a few small sand-throughs to metal (nickle sized).
What is the best material to use over 2k primer for small touch ups or the best way forward. I wasn't sure if I should use poly filler (i.e. evercoat rage), glazing putty, dolphin glaze (not sure what that is..just heard some folks talk about it on this forum), something else, or if I really should just spray on more 2k regular build and re-block it?
Thank you in advance.
Just got done blocking out two coats of 2k regular build (sprayed over epoxy). I plan to do a reduced epoxy sealer coat before going to base. After the blocking I found a few minor areas I need to touch up, i.e. a few pinholes and, one small gouge (very shallow, narrow, and about an inch long), and a few small sand-throughs to metal (nickle sized).
What is the best material to use over 2k primer for small touch ups or the best way forward. I wasn't sure if I should use poly filler (i.e. evercoat rage), glazing putty, dolphin glaze (not sure what that is..just heard some folks talk about it on this forum), something else, or if I really should just spray on more 2k regular build and re-block it?
Thank you in advance.
