gun selection and setup for 2100 production clear

P

Preacherman

Sprayed this the other day for the first time and was extremely impressed! Now its time to perfect my madness...i need to know the best setup for spraying this stuff super slick. Here's what i have to choose from...Sata 90 1.3, Sata Rp 1.4, Sata 3000 RP 1.2 and Sata 4000 RP 1.4. Which gun and then what would be the ideal pressure at the gun trigger pulled? Also, i'm using slow hardener in roughly 80-85 degree temps...is that correct? Also, should i try thinning this clear and if so how much? I ask all this not because the finish wasn't great...the car i did was a perfect match for factory peel...i ask because there will eventually be a car or truck that may need to be glass. Thanks in advance..God Bless!
 
An adjusted 1.4 tip will win most of the times, a 1.3 can be used is SOME guns but only RP's, LPH-LV a 1.3, in an HVLP gun is only going to spray thinner clears for large areas.
SPI is not going to work with a 1.2 without major problems as we use no fillers in our clears.
 
97 f150.jpg

97 f150 1.jpg

yet another awesome job by SPI's 2100 clear! Used a Sata 4000 1.4, full fluid, 35 psi trigger pulled, and 90% fan...very interested in trying the other clears in the near future.
 
You must log in or register to reply here.
Back
Top