W
westcoastkevin
Hello,
I am getting some bits back from sandblast today.
8 steel 16" wheels.
2 axles
steering rods.
Steel bumper.
engine and gearbox mounts.
4 leaf springs (leafs were separated.)
I am not a painter by trade.
I need some advice.
I have a suitable air supply and a Binks #7 gun. (I need to pick up an inline dryer though)
My wheels will be land rover green and the rest will be black.
What primer and paint should i use. I was told to check out SPI over on another forum. I am thinking epoxy.
How much primer (and other chemicals) will I need?
Can I use a dupont code or similar to spec the paint color green?
How should I prep the workpieces?
Is there a distributor near zipcode 28557?
Regards,
Kevin
I am getting some bits back from sandblast today.
8 steel 16" wheels.
2 axles
steering rods.
Steel bumper.
engine and gearbox mounts.
4 leaf springs (leafs were separated.)
I am not a painter by trade.
I need some advice.
I have a suitable air supply and a Binks #7 gun. (I need to pick up an inline dryer though)
My wheels will be land rover green and the rest will be black.
What primer and paint should i use. I was told to check out SPI over on another forum. I am thinking epoxy.
How much primer (and other chemicals) will I need?
Can I use a dupont code or similar to spec the paint color green?
How should I prep the workpieces?
Is there a distributor near zipcode 28557?
Regards,
Kevin