Here we go again, had a call Monday the epoxy sprayed a week ago will not feather at the metal.
OK the message said used waterborne to clean, so that leaves only two issues that can cause this, an acid film or cold metal temp but truck was in 80 degrees for 24 hours.
As we get through the call and a million questions on my end, I’m advised he use some rustrolium cleaner on the bare metal.
So now we get to strip the truck but like I told him, he can count his blessings because usually when I get this call the car is all painted and then the problem shows up.
We spend $30,000 a year on the tech books and most of you have noticed we are not cheap as far as handing out like candy.
I guess when I answer calls like this on a weekend and my wife hears what I say, she always comments about I like to ruin someone’s day, not so they made the decision not to follow the tech book and sometimes it can be costly.
Read the tech book, could save you some time and money.
OK the message said used waterborne to clean, so that leaves only two issues that can cause this, an acid film or cold metal temp but truck was in 80 degrees for 24 hours.
As we get through the call and a million questions on my end, I’m advised he use some rustrolium cleaner on the bare metal.
So now we get to strip the truck but like I told him, he can count his blessings because usually when I get this call the car is all painted and then the problem shows up.
We spend $30,000 a year on the tech books and most of you have noticed we are not cheap as far as handing out like candy.
I guess when I answer calls like this on a weekend and my wife hears what I say, she always comments about I like to ruin someone’s day, not so they made the decision not to follow the tech book and sometimes it can be costly.
Read the tech book, could save you some time and money.