N
ncornilsen
I laid down 3 coats of epoxy primer in the rear windshield and trunk gutter on my project car, 3.5 days ago.
Years ago i sandblasted it and put down POR15, which held up great. I used a really stiff wire wheel at low RPM to peel that stuff out for Epoxy.
Last night as i was drifting off, i woke up in a cold sweat... i cant remember if i went over those areas with sandpaper after i wheeled them. I probably did, i just cant remember doing it. I sanded half an acre of other metal on the project and can remember that. So im worried i missed that step, and these areas tend to rust if not perfect. I do recall thinking that the wire wheel i used left some deep scratches in the metal, and didnt really polish it... but i had fulled intended to aand anyway.
Its hard to get a razor blade in thier to do that test. I put some packing tape on it and pulled it twice in the same spot, nothing came up. Is there another way to test it? If not i supposed ill remove it and do it again, but would rather not.
Thanks!
Years ago i sandblasted it and put down POR15, which held up great. I used a really stiff wire wheel at low RPM to peel that stuff out for Epoxy.
Last night as i was drifting off, i woke up in a cold sweat... i cant remember if i went over those areas with sandpaper after i wheeled them. I probably did, i just cant remember doing it. I sanded half an acre of other metal on the project and can remember that. So im worried i missed that step, and these areas tend to rust if not perfect. I do recall thinking that the wire wheel i used left some deep scratches in the metal, and didnt really polish it... but i had fulled intended to aand anyway.
Its hard to get a razor blade in thier to do that test. I put some packing tape on it and pulled it twice in the same spot, nothing came up. Is there another way to test it? If not i supposed ill remove it and do it again, but would rather not.
Thanks!