N
ncsutp
Hey guys, steer me in the right direction here :
I've got a Devilbiss HVLP Finishline 3 that I've used quite a few times over past 5 years. I've recently started a new paint project and went to get the gun out of the cabinet, and come to find out that using the regulator on the gun will only let me adjust the inlet pressure to a max of 23 psi - which just happens to be the correct pressure to yield ~10 psi at the cap. Compressor set at 120 psi, no blocked / kinked lines, tried a different regulator and had the same 23psi max results - pointing to something clogged in the gun itself possibly. I did go ahead and spray some epoxy, and it sprayed fine. Anyone have any tips here? Thanks in advance.
I've got a Devilbiss HVLP Finishline 3 that I've used quite a few times over past 5 years. I've recently started a new paint project and went to get the gun out of the cabinet, and come to find out that using the regulator on the gun will only let me adjust the inlet pressure to a max of 23 psi - which just happens to be the correct pressure to yield ~10 psi at the cap. Compressor set at 120 psi, no blocked / kinked lines, tried a different regulator and had the same 23psi max results - pointing to something clogged in the gun itself possibly. I did go ahead and spray some epoxy, and it sprayed fine. Anyone have any tips here? Thanks in advance.