Saturday I sprayed one of my doors . Door was prep with SPI products. The 2K primer was wet sanded with 600 and then I sprayed 1 coat of reduced epoxy 1:1:1. The epoxy was allowed to dry overnight .After spraying the first coat of base I let it flash for 30 min. After spraying my second coat the top off the door had wrinkles in the base? Went ahead after 30 min and applied a 3 coat. So that brings me to my repair plan, I wet sanded the top of the door with 600 and plan to tape right were the side meets the top and cover the side of door. Then shoot 2 coats of epoxy, wet sand with 600 and respray the top with base coat. If this is the wrong approach please advise.