I've had some SPI epoxy primer for a few years and used for several projects. This time around I am remediating some rust in the bottom corner of a windshield channel. I sprayed two wet coats 35 min apart around 1AM this morning (don't ask, lol). Garage was around 74 but did cool a bit into the 60's overnight.
I just checked it and the flat surfaces seem fairly dry though can be marred by fingernail. However in the radiused corner at the bottom of the channel where some material accumulated, it's still very soft.
The car is supposed to be going to a windshield place first thing tomorrow and I still need to base / clear it.
Any suggestions? If I needed to remove it and go a different route how would I remove that still soft epoxy primer?
Thanks for any help. I'm a bit desperate as I've had to reschedule the windshield place once already.
I just checked it and the flat surfaces seem fairly dry though can be marred by fingernail. However in the radiused corner at the bottom of the channel where some material accumulated, it's still very soft.
The car is supposed to be going to a windshield place first thing tomorrow and I still need to base / clear it.
Any suggestions? If I needed to remove it and go a different route how would I remove that still soft epoxy primer?
Thanks for any help. I'm a bit desperate as I've had to reschedule the windshield place once already.