UPOL Dolphin Glaze

R

RayH

Promoted Users
I have a question about using this. During my final round of sanding for paint I have some small pin holes. My question is can I use this and just apply my base coat/ clear coat over it?
 
This on the underside of the hood. I used the regular 2 k SPI primer as a sealer , paint is metallic. The spots are on the edge of the hood were it meets the fender.
 
Dean, How much more do you have to reduce your products to spray nicely through those tiny/smaller guns?^^^^
 
Last edited:
hapcj7 said:
Dean, How much more do you have to reduce your products to spray nicely through those tiny/smaller guns?^^^^
Click to expand...
The instructions say the material should have the consistency of skim milk. Base is there at 1:1. Epoxy gets there and has worked at 1:1:1 for me.
 
Tungsten said:
Same question,what about high build .35mm tip. Must have to reduce it a lot?
Click to expand...
I can't think of a scenario for shooting high build through an airbrush, at least on a full size car type project.
If I just had a pinhole in high build I would dab paint in it with a tiny artists brush and then lightly sand it.
I use the airbrush when I find pin holes or scratches in sealer or base that need some glaze and then paint.
 
Dean Jenkins said:
I can't think of a scenario for shooting high build through an airbrush, at least on a full size car type project.
If I just had a pinhole in high build I would dab paint in it with a tiny artists brush and then lightly sand it.
I use the airbrush when I find pin holes or scratches in sealer or base that need some glaze and then paint.
Click to expand...
I use high build for DTM,just a weekend hack, and often get burn throughs so thought an air brush would work.
 
You must log in or register to reply here.
Back
Top