Roll or brush on?

S

Satatic

Can I do it?

I sprayed the underside of my car today, on jackstands. :D never again. Never did and kind of spraying on my back, I always just brush painted it. Man I was a sticky mess. Along with the floor and lots of other things. Glad I wore a suit and goggles. Though the tape pulled and I have a speckled wrist.

I really should have gotten 2 gallons. I did most of the underside of my 68 camaro and all 4 wheel wells. I skimped on the trans tunnel area because it was going so fast. Probably used way to much in my wheel wells.

Ended up tossing the philcan, I think it would have cost more in gun wash than the can is worth. I used about 1 pint to clean the rest of the gun.

The stuff goes fast so mix it in the can, I tried using mixing cups and that got old fast plus I was wasting product.
 
Bedliner. For future cars can the product be rolled or brushed?
 
sure it can or next time we can walk you through the adjustments and spraying.
 
it worked really good with my lizardskin gun. little reducer and it went on nice and smooth.
 
I didnt have issues spraying its more the laying on my back with a car 1.5 feet over me trying to maneuver. Hose dragging on me, running over the lamp cord, wheels on the creeper stopping every time I try to turn. Can't expect 100% of the material to end up on the car right? I'd spray it again in a bed but once under a car is enough for me.
 
I'd bet if you're going to roll or brush it on you would have to mix it in smaller quantities or the batch will kick before you have it applied. I seen some really nice examples on the old forum where one of the users is spraying it on really slick. The last time I used it I was hiding some poor patchwork done by a previous shop so maximum texture was the goal. I would like to know how to lay it on slick, Shine-how much reducer are you using?
 
You must log in or register to reply here.
Back
Top