I sprayed spi epoxy reduced for the first time this week. 25% reduced as a sealer and I was amazed how nice and flat that laid down. My Motocryl single-stage however is a different story with orange peel. Trying to figure out what adjustments to make, and after reading all the posts I can find I’m still confused. Not sure, but think I should adjust the pressure up just a bit and the fluid down just a tad?
The last spray was basically the same settings I used to spray the 25% reduced epoxy. Iwata Lph400 2.75 turns out on fluid, fan just under full open, and pressure with trigger pulled at 26psi. Regulator on wall is open to 120psi. Pass overlap at 50% about 5-6” from the panel.
Suggestions to this newbie will be much appreciated. Thanks
The last spray was basically the same settings I used to spray the 25% reduced epoxy. Iwata Lph400 2.75 turns out on fluid, fan just under full open, and pressure with trigger pulled at 26psi. Regulator on wall is open to 120psi. Pass overlap at 50% about 5-6” from the panel.
Suggestions to this newbie will be much appreciated. Thanks