Need some advise on this quarter panel

6

6t7goat

This is the quarter panel from my 78 trans am. I found the damage when I was stripping all the old paint. It was loaded with bondo. It is seriously gouged and I cant get behind much of it. Any Ideas as to how to work it out would be appreciated. 102_3278.jpg
 
Last edited:
I don't know what equipment you have available so your options may vary.

A series of welded studs along the low line of of the major crease with a flat clamp and pull with a frame machine while taping the edges.

Cut an access panel in the inner wheel well and use conventional body tools. Adds the job of welding the access panel back in but you could work that dent quite well.
 
Hire a PDR guy to come over and work it for you, and they will teach you some tricks at the same time.
 
You must log in or register to reply here.
Back
Top