Hocky puck 3100 clear.

[Barry]

I thought this might be of interest to you as I do this with all the clears on a regular base for testing.

This puck is about three months old and flexible!!

It is fully cured because it is 3100 speed clear; if it were a normal cler at 3/4 of an inch thick, it would take closer to 9 months with no sun.

Very proud of this clear as try to find another speed clear at this thick that will even make it out of the mixing cup without crumbling up into pieces

 

[Whitesnake]

That’s awesome. I gotta get me some.

 

[crashtech]

I love Speed Clear! Just need to home in on how much to make, last time I used it I was about an ounce short and had to really run to mix more.

 

[Whitesnake]

Now that could be a problem! Lol nobody likes waste but I suppose a little left over is better than not enough, with speed clear anyway.

 

[crashtech]

I shouldn't be so stingy, but part of the deal is that I have been able to get a little more of it on the panels now that I have more experience with it, so basically I need to start my notes over again. I really do hate wasting it, since it's quite a bit more expensive than the other clears (worth it in many repair situations, though).

My favorite use is to use it at the end of a really long day, the kind of day where stuff has gone sideways and it's already close to 8PM. Now I get to walk in, hammer 2 coats, and call it a day instead of waiting around for flash times.