The last few days I’ve been getting major orange peel in the second coat of epoxy. I’ve shot several pieces before this without issue but haven’t been able to figure this out. It’s 97 degrees outside and probably 95 degrees inside where I’m working, which may be the problem. Here’s my process: mix epoxy 1:1, induce 30-60 min, spray a coat (all filters removed from gun), remove and seal cup from gun, clean gun, flash at least 30 min, stir primer and reattach cup to gun start to spray and get major orange peel. I’ve tried increasing the air pressure, reducing the epoxy and various other things but haven’t found the answers. Please let me know if you have thoughts. I’m getting tired of sanding orange peel only to spray on more thanks!