sprint_9
Rookie
I need to repair a box side on my C10, I think its safe to say this box side is cursed. I stepped on a stupid floor jack and tipped the damn thing into the box side. As hard as it it Im shocked there isnt more damage.
My first thought was to try a paintless dent repair guy to see if he can get the dent out and then just treat the chip as a rock chip, a coat of base and then fill with clear till its level and then cut it flat when I cut and buff the outside of the box later this fall.
My second thought was to repair on my own if he cant get the dent out. Im not really sure what steps I should take if this is the case. I would assume sand the clear, not sure on a grit to use?, and then epoxy, and then probably some dolphin glaze, spot in base and re clear the box side?
My first thought was to try a paintless dent repair guy to see if he can get the dent out and then just treat the chip as a rock chip, a coat of base and then fill with clear till its level and then cut it flat when I cut and buff the outside of the box later this fall.
My second thought was to repair on my own if he cant get the dent out. Im not really sure what steps I should take if this is the case. I would assume sand the clear, not sure on a grit to use?, and then epoxy, and then probably some dolphin glaze, spot in base and re clear the box side?