69fastback
New Member
I'm receiving my car back from a restoration shop that's 90% in epoxy but has some bare metal areas on it I need to address before any rust starts forming.
Entire Hood both sides has been DI sanded to bare metal.
4 Patch areas on quarters and front valence where we filled in side marker light holes.
Can I just hit the bare metal spots with epoxy primer on a roller? It's below freezing in my detached garage right now but I can raise the temp for a few hours using a kerosene heater and some space heaters in my garage.
This would be good to know for any future metal cutting that exposes anything - I want the entire car to remain encapsulated in SPI epoxy.
Entire Hood both sides has been DI sanded to bare metal.
4 Patch areas on quarters and front valence where we filled in side marker light holes.
Can I just hit the bare metal spots with epoxy primer on a roller? It's below freezing in my detached garage right now but I can raise the temp for a few hours using a kerosene heater and some space heaters in my garage.
This would be good to know for any future metal cutting that exposes anything - I want the entire car to remain encapsulated in SPI epoxy.
Last edited: