C
cstrom72
Hey everyone-
Im restoring a 1968 Fastback that I pulled out of a barn last week. It has a good amount of surface rust and got bumped in the passenger side rear slightly but The frame rails and rockers are in great shape except for drivers side rear frame rail has a little more than surface rust and I will most likely replace- the floor boards are toast. I will replace the inner cowl as well. Question is which would I start with?
Ill be doing this in my 3 stall garage and I have plenty of room but I want to make sure she stays straight while im replacing all this stuff. Im even looking into a rotisserie
The car was completely disassembled by the P/O so when I got it home I started putting the doors, hood ,front fenders and deck lid back on. I think i will spend the next few days getting these parts aligned perfectly before anything gets cut.
What should I start with? Floor? Cowl? rear quarters? tail light panel? Thanks!
Im restoring a 1968 Fastback that I pulled out of a barn last week. It has a good amount of surface rust and got bumped in the passenger side rear slightly but The frame rails and rockers are in great shape except for drivers side rear frame rail has a little more than surface rust and I will most likely replace- the floor boards are toast. I will replace the inner cowl as well. Question is which would I start with?
Ill be doing this in my 3 stall garage and I have plenty of room but I want to make sure she stays straight while im replacing all this stuff. Im even looking into a rotisserie
The car was completely disassembled by the P/O so when I got it home I started putting the doors, hood ,front fenders and deck lid back on. I think i will spend the next few days getting these parts aligned perfectly before anything gets cut.
What should I start with? Floor? Cowl? rear quarters? tail light panel? Thanks!