Ye ole rust issue

1

1972GMC

So I want to get rid of the rust and epoxy the inside of my doors. 1 problem, the holes on the inside of the door are too small for me to maneuver a gun or a brush. Just wondering if anyone has any tips or tricks for this.
Thanks
 
You could use an undercoat gun with a flexible spray tip or extended wand to get into those tight areas. Your local jobber should have them.
 
here's what i do tape holes in door mix up epoxy dump in door roll around till covered pull tape out of drain hole drain in cup do next door Barry told me that trick works good
 
JWolfe;n74415 said:
here's what i do tape holes in door mix up epoxy dump in door roll around till covered pull tape out of drain hole drain in cup do next door Barry told me that trick works good
Click to expand...

I can already see myself making a huge mess if I attempt that lol.
Any specific undercoat gun you recommend?
 
yes it can b messy lots of cardboard necessary but it does seal it up good
 
You must log in or register to reply here.
Back
Top