What is your favorite tool to use 3" roloc discs

S

Senile Old Fart

Just like the title, what is your favorite tool to use 3" Roloc discs on?
I am in the tool buying mood :)
 
I got a deal on a Snap On PT410. It's a bad mamba jamba. But before I took delivery I made sure the tool man could loosen it and flip the lever around to the bottom. Having it on the top is dumb. Oh, and I never use the side handle. Took a while to get used to the power, the damn thing is a brute.
 
crashtech;26722 said:
I got a deal on a Snap On PT410. It's a bad mamba jamba. But before I took delivery I made sure the tool man could loosen it and flip the lever around to the bottom. Having it on the top is dumb. Oh, and I never use the side handle. Took a while to get used to the power, the damn thing is a brute.
Click to expand...

Is it as big an air user as the pdf. says?
 
I have 4 or 5, 20 year old Chicago Pneumatic die grinders I use. I also have a newer one, tho it does the job, it isn't as good as the old ones.
 
Senile Old Fart;26726 said:
Is it as big an air user as the pdf. says?
Click to expand...
I haven't noticed it being a problem, but then again I don't think I run it full blast. There is an adjustment. It doesn't run my air down noticeably when I'm using it. I think it gets so much more done while used it's actually not on as much as my smaller one would have been.
 
Dub;26727 said:
I have 4 or 5, 20 year old Chicago Pneumatic die grinders I use. I also have a newer one, tho it does the job, it isn't as good as the old ones.
Click to expand...

I had an older CP die grinder I used and abused. When the garage burnt down I lost it.

I now have a IR mini right angle grinder, but it doesnt have near enough power for a 3" disc for my likings.
 
You must log in or register to reply here.
Back
Top