You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Doors were sanded to bare metal
Two coats of SPI epoxy
They needed a little bodywork to make them straight
A coat of SPI epoxy to seal
Two coats of Evercoat Slick Sand
I'm way behind in updates so now I will get into some of the harder work
The first thing we did was start removing the old patch and left front floor pan
Behind the roll bar the floor pan had a little rust. We did not want to take out the roll bar so we patched it
New floor pan and toe board installed
Rear floor patch
Before the seat riser was installed it was epoxy primed
Welds ground down
