J
JayL
Hey all,
I hope this is a simple question but the more I learn the more I realize that most times the question is simple but the answers are not.
How do you all suggest one either gets rid of tape lines or sprays so that you don't get them in the first place?
I taped off most of the front of the guitar as I am bursting the back/side color around to the front.
You can see the line in the photo below that the edge where I masked off the front built up after 2 coats enough to see it.
Once I realized that these lines were going to be too noticeable I decided to stop with the airbrush as I figured I would be doing some sanding and will have to re do the burst which is not the end of the world.
Suggestions?
Thanks
Jay L
Tampa, FL
I hope this is a simple question but the more I learn the more I realize that most times the question is simple but the answers are not.
How do you all suggest one either gets rid of tape lines or sprays so that you don't get them in the first place?
I taped off most of the front of the guitar as I am bursting the back/side color around to the front.
You can see the line in the photo below that the edge where I masked off the front built up after 2 coats enough to see it.
Once I realized that these lines were going to be too noticeable I decided to stop with the airbrush as I figured I would be doing some sanding and will have to re do the burst which is not the end of the world.
Suggestions?
Thanks
Jay L
Tampa, FL