O
Outlaw
I had asked this question on another post, but lost my way when I went to look for it again. My welds are tight with no visible pin holes, but I assume there may be some I could have missed and also where I could not get a light behind to check. I am spraying three coats of epoxy over the panel that it welded. It will get a heavy coat of former SPI Bedliner (my last half gallon). I am considering waving the step of fiber glass filler over the welds in this area. I have the fiber glass filler and its not a big deal to do it, but I would consider elinimating this step if its just adding more material and could be avoided. Pros, Cons?