Carbon Guide Coat & Clear Coat

No I am wet sanding all the way up to the 1500/2000 step. then that is done dry with the DA then back to wet with 3000-5000. Seems I get a more consistent scratch with the DA at the finer grits.

I'm so picky when it comes down to the final finish...it is hard to please myself most times.

The powder stays on there fore the most part. Once you put it on, rinse it real well to get the excess off. Once you have sanded the area once and removed all guide coat, go back over it one more time. It will wash out some, but if you go right back over it you know that it is good.
 
the v-series compound has done wonders for the final finish for me . it gets it so much clearer than the presta did .
 
I may give that a try on the next one. I have been very satisfied with the newer presta over the 3m.
 
i gave up on 3m years ago . worked me to death . i refuse to use anything mequiars period. i was using presta but went back to cg. the sample pack is only 20 bucks.
 
Thanks for updating Jeremy.. I'm still a long ways out from paint on anything.. I'm going to give this a go when the time comes though.
 
You must log in or register to reply here.
Back
Top