T
Tiggie
I was practicing and exploring my spray technique before conquering the big part of my project car later this week.
I really hammered on the base on one part. Got a gathering of metallic in a small run.
Can I sand out the run and reapply base or do I need to sand, seal (25% reduced epoxy), and start from base coat 1?
Base is Nason and is used hardener. Did not clear it yet.
I appreciate you all answering my potentially dumb questions. I’m learning as I go.
I really hammered on the base on one part. Got a gathering of metallic in a small run.
Can I sand out the run and reapply base or do I need to sand, seal (25% reduced epoxy), and start from base coat 1?
Base is Nason and is used hardener. Did not clear it yet.
I appreciate you all answering my potentially dumb questions. I’m learning as I go.