J
j b
What are your thoughts on welding up pin holes instead of putting in a patch?
I'm working on a 1968 C10 passenger door bottom.
I'm obviously going to have to use some patch panel for parts of this. But, the patch panel does not have the sharp bends and definition of the original door and I want to keep it as nice looking as possible. Most of this will not be visible but I'm trying to make my cut line on the bottom side of the door for the inner part. I think I'm going to have to make some small pieces to go up at the front also.
I'm working on a 1968 C10 passenger door bottom.
I'm obviously going to have to use some patch panel for parts of this. But, the patch panel does not have the sharp bends and definition of the original door and I want to keep it as nice looking as possible. Most of this will not be visible but I'm trying to make my cut line on the bottom side of the door for the inner part. I think I'm going to have to make some small pieces to go up at the front also.