Arrowhead
Oldtimer
Owner wants a show quality finish on the Art Morrison chassis for the '57 I'm working on. If that's not enough it's going to be a metallic grey. It's the same color I've used before and I'm thinking this is going to be very difficult to pull off. I shot two coats of epoxy today and not sure how I'll get a metallic BC/CC on it and have it lay consistent. The tight corners and multiple angled surfaces are just begging for runs and blotchyness. Not to mention it will be impossible to keep a wet edge going. Any tips on how to make this work? Super slow reducer for the base? Retarder in the clear? I grabbed a cheap detail gun today just get the primer done and it worked pretty good but I don't think it's going to cut it spraying a metallic. (yes, I already suggested powder coating but he is set on paint) Have some filler work do do first before painting it. Any tips would be appreciated.