SPI PLASTIC ADHESION PROMOTOR

  • Thread starter streamlinecollision
  • Start date
S

streamlinecollision

Any plans to put SPI Plastic Adhesion promotor in spray bombs ? Would be helpful for small repairs.
 
  • Like
Reactions: AAE
Sorry, I looked at an automated aero line a couple of years ago and for what few products, I would package, it was not feasible. Cost was about $90,000 for what I would need.
We have two state of art aero packers within 100 miles from us but I lose control of quality, so never will.
 
ahh yes if you wanted to go that route you can get preval sprayers for 6 bucks at home depot. same thing without the eastwood price tag. sureshot sprayers are way more expensive and you charge them with your compressor but they will last years and years. guess it depends on what each person is looking for.
 
The sure shot and the prevals are great ideas.
The sureshot is a forever lasting gun and can be used for wax and grease remover and things like the adpro as well as the blending agent.
Last I looked $50 or 60 but been awahile.
 
Also, will the steel container work for both Solvent and Waterborne W&G removers, as well as the plastic adhesion promoter? Or would they cause rust?
 
I see Titan makes a Sure Shot copy, does anyone know if it is any good?
They are ok. I have spi waterborne w&g in one and solvent borne in the other. The triggers seem to get sticky after a while of non use so can't say for sure if they are as good as the real deal.
 
Competitors spray cans run around $22.00. There is 300 ml of adhesion promoter in a can and the rest is propellant to get it out of the can. A quart of SPI adhesion promotor is a little over 25 and would equal 11 spray cans. I recommend a cheap touch up gun and a quart.
 
Last edited by a moderator:
Back
Top