Small Gun

[Speed Thrills]

I know there’s a lot of posts about this, but I searched “SPI forums small detail gun”, on google, and didn’t get a lot. I did find a dead link to eBay.

What’s out there to get in the engine compartment and trunk? It doesn’t have to be, and shouldn’t be expensive.

The 20 ounce cup and regulator on my Iwata really limit accessibility. Maybe there’s a smaller cup available for the LPH400 that I have?
I’m also thinking about a 90° fitting at the gun, and moving the regulator down a couple feet.

 

[Jim C]

porphis 338. just bought this gun in a 1.2mm. its cheap, well built and sprays way better then my sata 4400 that is 3-4 times the price.

 

[Speed Thrills]

porphis 338. just bought this gun in a 1.2mm. its cheap, well built and sprays way better then my sata 4400 that is 3-4 times the price.

That begs another question: is a 1.2 tip big enough for SPI epoxy and SPI bc/cc?

 

[Jim C]

i wouldnt shoot a whole car with it but smaller areas....yeah no problem

 

[Speed Thrills]

i wouldnt shoot a whole car with it but smaller areas....yeah no problem

Sounds good. Yeah, I’m just looking at trunk, engine compartment, jambs. Thanks.

 

[chevman]

I'm looking for a small gun, and if Jim likes it that much, then I'm in.

 

[Jim C]

so far so good. i just shot a very odd shaped fiberglass piece today. i usually get runs on this this on the inside edge when i spray them. porphis for the win on this one. 4 coats of universal. atomized super fine, not a single run. so far this thing has been great. i am just so used to sata that i cant believe i got it for the price i paid. longevity and customer service when it comes to parts has yet to be seen but overall quality, i am impressed.

 

[chevman]

Mine is on the way from China. For a high quality gun at that price, maybe I should have ordered two, incase I need a part for the first one.