Is the only downside to higher PSI while spraying (general question, epoxy/base/clear) that you will have excessive overspray?
I have been spraying epoxy at varying pressures, and I'm amazed at how smooth I can get it over a 80-220 grit surface. After a couple coats it's close to glass. Today I had some epoxy that had been mixed overnight, and it was spraying like it had thickened up a little too much, so I upped my pressure to 30 and it turned out incredibly smooth.
So now I wonder, is the only downside excessive overspray?
I have been spraying epoxy at varying pressures, and I'm amazed at how smooth I can get it over a 80-220 grit surface. After a couple coats it's close to glass. Today I had some epoxy that had been mixed overnight, and it was spraying like it had thickened up a little too much, so I upped my pressure to 30 and it turned out incredibly smooth.
So now I wonder, is the only downside excessive overspray?