sprint_9
Rookie
Today I mounted the box onto my C10, everything going good until I started scrutinizing. The up and down gap between the cab and the box on the drivers side was at much more of an angle the passengers side, closer at the top and father away at the bottom. Then I sat down on a stool and sighted across the truck and it hit me , the drivers side of the box was way jacked up. So I got the tape measure out and rough measurements put the rear drivers side of the box 1.5 inches higher than the passenger side of the box. I started measuring on the frame and things arent too bad in front of the rear axle, but get closer to and then behind the axle they go south quick. The measurements on the frame mirror what is shown with the box.
So now Im faced with how to go about trying to at least get this in the ballpark. Does anyone have any suggestions?
So now Im faced with how to go about trying to at least get this in the ballpark. Does anyone have any suggestions?