A
angrywombat4
It came out fairly well for a home spray first timer deal. Some trash and a few runs, but it should buff out.
SPI epoxy underneath, Motobase LV from Chad, 3 coats, and SPI universal clear 4 coats.
However......
When I pulled it out of the "booth" this afternoon, I notice that I missed a panel on the 4th coat of clear. This was after about 3 hours on final coat. My exhaust filters had plugged up enough that the overspray was pretty bad on the last coat and probably why I missed it.
Should I wait and sand that panel and put the fourth coat on it, or will 3 coats be enough to cut and buff it. Not doing a show finish, just a nice street driver. I think I put the clear on fairly heavy, used a Tekna Copper and it seemed to hose it on well. Hence the runs I have to fix!
Any advice?
SPI epoxy underneath, Motobase LV from Chad, 3 coats, and SPI universal clear 4 coats.
However......
When I pulled it out of the "booth" this afternoon, I notice that I missed a panel on the 4th coat of clear. This was after about 3 hours on final coat. My exhaust filters had plugged up enough that the overspray was pretty bad on the last coat and probably why I missed it.
Should I wait and sand that panel and put the fourth coat on it, or will 3 coats be enough to cut and buff it. Not doing a show finish, just a nice street driver. I think I put the clear on fairly heavy, used a Tekna Copper and it seemed to hose it on well. Hence the runs I have to fix!
Any advice?