Door hanging stand

[bmenard]

Looking to see what is being used to hang door shells, fenders etc to paint both sides. Sick of hanging off wires and stuff blowing around. Thought of making something with an engine stand but would like to be able to do 2 doors at once. Whats out there?

 

[MP&C]

Here's one I made using some "tripods" I already had in stock. We did have to add solid block at the bottom for counterweight, to keep things upright when there's only one door while bolting things up... Used another to mount up the front fenders...

Front fenders were both prepped with DA and 80 grit..

SPI Epoxy is mixed to allow for induction...

The door handle backing plates had not yet been installed on the back side of the door skins, so a coat of epoxy was sprayed on both, and then bolted together to allow to cure..

A good shot of the door paint fixture in action...

Two coats applied...