Compressor Seized in Middle of Coat

It's all good. It blocked out just fine. Better than I had hoped, actually. So good, in fact, that I put a few coats of build primer on afterwards. Retracing my steps, I'm almost positive that I had some junk in the gun. I remember having to increase the paint flow a bit and my test spray pattern was a bit wonky. Should have stopped then and there...rookie mistake. Nice to know that the paint isn't compromised, though.

Thanks, everyone!

Chris
IMG_5304.JPG

Camera has trouble focusing on the monochrome image, but it's not rough anymore.

IMG_5303.JPG

Another attempt at showing it. You can just make out the darker spots that the blocking hasn't touched yet. This all came out eventually after a few hours of blocking.
 
Last edited:
Back
Top