Cleaning before epoxy

E

Elou795

So here's what i'm going to do and tell me if this is ok, I blasted the inner door frames with glass bead because there are a bunch of screw holes and rough edges I hung them and soaked them with waterbourne wax & grease remover, I'm going to let them sit for an hour to dry them blast them with compressed air. Next I was going to hit it again with the solvent wax and grease remover, but how long should it sit before I dry it with air, or is this last step needed. I noticed that the info sheet has been modified a while back to include 2 cleanings with both types of wax and grease removers where as before the waterbourne was the only one recommended.

Thanks
 
I believe on an engine painting question, Barry once said if you soak it in solvent W&G to let it air out for 4 hours.
 
I'm assuming when you say soak you are drying with a clean rag before the W&G dries?
After that, you can blow dry anytime.
The two-step is an option as we learned a lot of high-end shops have been using that method.
 
Also if engine let set longer like said, if Corvette let set overnight if cleaning raw fiberglass.
Nothing is cut and dried or use of common sense when using chemicals. LOL
 
Back
Top