This vette I'm working on has a lot of paint on it, I used the existing film build to level out a lot of the fiberglass by DA'ing with 180 and then water sanding starting with 180 grit and working up. Also have areas of bodywork where I repaired cracks and old collision damage so there's feathered in filler/lacquer primer surfacer. On much of it I ended up using slick sand to get it nice and level.
I was thinking I could use SPI epoxy primer over all this (finished bodywork, primer, slick sand) and block sand it to 4 or 600 and call that sealer for base. Am I correct? Or do I need to add another coat of reduced epoxy as a sealer?
I was thinking I could use SPI epoxy primer over all this (finished bodywork, primer, slick sand) and block sand it to 4 or 600 and call that sealer for base. Am I correct? Or do I need to add another coat of reduced epoxy as a sealer?