Search results

It's almost impossible to find one with an original seat that is not torn, same with the bagger. When i came across this i just could not pass it up for the price. couple hundred bucks in tires, blade, tips, clutch ( a lot of adjusting time), filters, plug and now 3 oil changes and it appears...

yes! I bought this strictly for its bagging abilities though. a new blade and hi-lift tips and this thing will pull the dirt out of the ground.

Just picked one up myself about 8 months ago. a little newer than the Gump model, but basically the same. this one was a low hour original owner/motor/tires/blades/clutch and all when i picked it up. still trying to figure out if im going to strip it down and paint it or not.

I would see no benefit to top coating underneath the deck, it would ultimately just get damaged from any coarse debris the blades throw up anyway. the epoxy lays out slick, it does not have a rough texture to it.

we remove them for everything we spray. cut a 1inch slit in the center of the screen, stick your finger through it and pull. it should come out in one piece with ease. i do 10-15 at a time for future use.

Is that a beretta in the background?

I'm not going into detail about how these are being tracked or stopped as not to risk an exploit, but apparently i have ticked off one of these bots.. between 3:16am and 4:33am this morning we had 6,803 account creation attempts blocked from the same IP address in Moldova.

this one and the one his former painter spun off are the only ones i pay any attention to anymore.

Sorry for the bad photo- This weeks episode of Iron Resurrection. They have been a normal paying customer for a while, no promos or anything of that nature, so i was a bit surprised to see this. A little bit later in the show, i think when he is setting up to do some striping, there are a...

yah, link is fine

just dumped 74 more accounts created over the past 6 days.:oops: I hope these are just bots and someone is not actually wasting their own time creating these profiles..

Yah, i notice too that they love to dig up 5 year old posts and make generic comments on it.

sorry, i meant "report" it.

I've deleted close to 90 new spammer accounts in the past 2 days, there are still 10 or so accounts that joined in the past week that i am questioning / watching. there is a vetting process when users join and their posts have to be approved, but if you see any questionable posts that look like...

Though this thread seems to be at its end, i just want to add some info in here for future lurkers- The activators contain resins as well, not just the clear itself. If you under activate the product you are killing the solids content (watering it down) along with creating other issues such as...

Yes, he has officially cut the cord. He has been semi-retired since December 2022, only answering tech calls and coming in the office for a few hours one or two times a week. He has been traveling quite a bit over the last year, but the trips were always being planned around cell phone...

the epoxy can be tinted up to 5% using a tint straight off the mixing machine. The epoxies can also be mixed together for different shades.

we don't recommend it as it will not last very long, but the customers that have done this recommend shooting it with adhesion promoter first.

1,025. It's set up to auto clean accounts that have not been active in over 1.5 years as well.

we typically run straight 870 or 885 in ours. it seems to do ok as long as the epoxy has not set too long.